B&C Technologies HP series Betriebsanleitung PDF herunterladen (Seite 35)

Appendix A

34

Creating a Heat Cycle

Funct ion 1 2 3 4 5

Cool Down

Bal Load

Drain

Cold Water

Hot Water Yes Yes

Heating Yes Yes Yes Yes Yes

C 90 90 90 90 90

Chem 1

Chem 2 Yes

Chem 3

Chem 4

Hard Water (Chem 5)

Relay 16

Relay 11 (Aux Fill)

Relay 12 (Injection Flush) Yes

Relay 13 (Balancing)

Motor 1 1 1 1 1

Speed RPM 42 42 42 42 42

Relay 17 (Chem 6)

Relay 18 (Chem 7)

Relay 19 (Chem 8)

Relay 20 (Aux Drain)

Relay 21

Relay 22 (Buzzer)

Relay 23 (Cold Spray)

Relay 24 (Hot Spray)

Level cm 24 24

Temp C 90

WDT m:s 9:00 30:00 5:00

Time m:s 1:00 7:00

End Step

St ep

Any cycle can be converted to a heating

cycle by inserting a step after the fill, and

setting the end step condition to a

temperature (See Step 2 in the

illustration to the right).

Step 1 - Fill to a water level with hot

water. Heat is on, and will engage when

a minimum water level is met.

Watchdog timer of 9:00 allows time to

fill before an alarm is generated. Step 1

ends when the water level is reached.

Step 2 - Heat output is on. Watchdog

timer of 30:00 allows time to heat to the

required temperature before an alarm is

generated. Step 3 ends when the target

temperature is reached.

Step 3 - Heat output is on, Chemical 2

output is on, Relay 12 (injection flush) is

on (not required for machines with

plastic vacuum breaker). Step 3 ends

when a time of 1:00 elapses.

Step 4 - Top off step, same outputs as

step 1.

Step 5 - Heat output is on in order to

regulate temperature during the agitation

phase. Step 5 and the entire cycle are

complete when a time of 7:00 elapses.

Refer to the earlier sections in this

manual for a full explanation of each

step.

1 2 ... 30 31 32 33 34 35 36

Kommentare zu diesen Handbüchern

Keine Kommentare